Device Selection Menu
When you press the DEVICE
button on your remote control,
the Device Selection menu
appears. When NetCommand TM
has not been setup, the Device
Selection menu allows you to
select the input for viewing.
When NetCommand TM is setup
the Device Selection menu
allows you to select the device
for viewing, select audio from
the TV speakers or A/V Receiver,
power compatible devices On or
Off, and verify the destination of
signals.
Video
Connection Section
Figure I. Device Selection menu after NetCommand TM has been setup.
Device Section
When the Device Selection menu is displayed, the
Device or Input you are currently viewing shows a
gold-colored icon.
To select another device or input, use the ADJUST
button • • '& or V, to move the yellow highlight
among the devices. Press ENTer to select the
device you would like to view and hear. The TV
inputs are automatically changed. If NetCommand TM
is setup, the inputs on compatible A/V Receivers
are automatically changed at the same time.
Power Devices On/Off
Some devices will power On automatically when you
select to use the device. These devices will power
Off automatically when you turn Off the TV. For
devices that do not power On or Off automatically
display the Device Selection menu, ADJUST • or
• to highlight the device icon and press POWER
on the remote control. For the A/V Receiver, press
the AUDIO button to move the navigation to the
Audio Section. Highlight the A/V Receiver icon and
press POWER. If you press POWER on the remote
control when the Device Selection menu is not
displayed, the TV will turn Off.
Audio Section
When a NetCommand TM compatible legacy IR
controlled A/V Receiver, or HAVi amplifier has been
connected to the TV and added to NetCommand TM
Setup, an icon for this device will appear in the
audio section. Use the AUDIO button to change
navigation to the audio section. Then use the
arrow buttons to select the TV speakers icon or
the A/V Receiver icon. Press ENTer to change the
audio selection. Use the DEVICE button to return
navigation to the Device Section.
Video Section
The TV icon is the destination for the currently
selected device shown in the Video Section.
Connection Section
The Connection Section shows the other devices
that are currently connected to the device
highlighted in the Device Section.
For example, if the Digital VHS (D-VHS) is currently
recording from ANT-DTV, when you move the
highlight to the ANT-DTV icon, the D-VHS icon will
appear in the Connection Section. This icon will
disappear when you move the highlight to another
icon.
To Next Page
Loading...
Need help?
General
