Remote Control Buttons: Device Menu Button
ADJUST Button
ENTer Button
DEVICE MENU Button
\
Figure 1. Remote Control (DEVICE MENU, ADJUST
and ENTer buttons)
Device Menu Button
The DEVICE MENU button displays the Transport
playback devices. A second press of this button will
display the menus for NetCommand TM compatible
IEEE 1394 devices. Menu access varies by device.
While watching a NetCommand TM compatible
traditional IR controlled or an IEEE 1394 device,
press the DEVICE MENU button once or twice, to
display the menu for that device.
When the Device Selection menu is displayed, and
a HAVi IEEE 1394 device is highlighted, pressing
the DEVICE MENU button will automatically display
the menu for that device over the current source.
The HAVi IEEE 1394 device does not need to be the
current source. Some IEEE 1394 devices do not
have a menu to display. Check with the Owner's
Guide of the IEEE 1394 device.
For playback devices, the first time you press the
DEVICE MENU button, it displays the Transport
menu. A second press of this button displays the
menus for NetCommand TM compatible devices.
Menu access varies by device.
When the menu for the device has been displayed,
to navigate, use the ADJUST _, =, V and ENTer
buttons. For some NetCommand TM traditional
devices you will also be able to use the number
buttons and other additional buttons.
For traditional DVD players, the Device Menu is also
known as the setup menu.
To Next Page
Loading...
Need help?
General
