Remote Control Buttons: Special Features and Record
Special Features
For both NetCommand TM compatible traditional IR
devices and IEEE 1394 compatible devices, these
buttons on your TV remote control may also operate
the similar functions for the device:
CHANNEL
VOLUME
MUTE
Numbers 0-9
HOME
ENTer
ADJUST
INFO
The exact function will depend on the device being
used. See the Appendix for additional information.
Record Button
The Record button allows you to record on both
NetCommand TM traditional IR devices and IEEE
1394 compatible recording devices.
To record from Ant-A, Ant-B, Ant-DTV or other
devices, see NetCommand TM Controlled
Recordings.
AV Disc Search
NetCommand TM is able to search to a specific time
in a recording on an IEEE 1394 AV Disc.
1. Start the playback of the desired track on the AV
disc.
2. Use the number buttons to enter the time code
position of hours followed by minutes. For example,
to enter one hour and twenty-two minutes (1:22)
into the track, enter 1, 2, 2.
3. Press ENTer to skip to the time code position.
4. To cancel the request or to start over, press
CANCEL instead of ENTer.
Recording On A NetCommand TM
Traditional VCR
Pressing the Record button will function the same
way as pressing the record button on the VCR's
remote control or front panel.
To record directly from antenna or cable:
1. Display the Device Selection menu. Highlight the
traditional VCR and press POWER to turn on the
VCR. If necessary, press GUIDE to select the input
the VCR is on, such as Antenna input (or line input).
2. Press ENTer to switch the TV to the VCR.
3. Select the correct channel for recording on the
VCR and then press REC to start recording. You
will need to manually stop the recording at the end
of the program. OR...
4. Press the DEVICE MENU button to display
the VCR's menu to schedule a delayed recording
directly from antenna or cable.
To Next Page
Loading...
Need help?
General
