OSCILLATORS:
The Voltage Controlled Oscillators (VCO1 and VCO2) are the Minitaur’s primary source of sound. Page 9
OSCILLATOR PARAMETERS:
VCO 1
Choose either a Sawtooth (LED OFF) or Square
Wave (LED ON) as the waveshape for VCO 1.
VCO 2
Choose either a Sawtooth (LED OFF) or Square
Wave (LED ON) as the waveshape for VCO 2.
VCO 2 FREQ.
VCO 1 is the master oscillator. This knob sets the
Frequency offset (musical interval) of VCO 2 from
VCO 1. The offset range is +/-1 octave. The center
position tunes VCO 2 in unison with VCO 1
VCO 2 BEAT
This knob allows you to set a fixed frequency offset in
Hz (cycles per second) for VCO 2. The range is ± 3.5
Hz; the default value is zero (no offset).
NOTE SYNC
Forces both oscillators to start at the same time,
eliminating any phase differences at the start of each
“Note On” command.
UNDER THE HOOD
OSCILLATOR PARAMETERS:
10
To Next Page
Loading...
Need help?
General
