•
Press the Menu Select button below Acpt to
accept the request to upgrade immediately.
•
Press the Menu Select button below Dlay to
delay the request to upgrade.
•
Press the Menu Select button below Rej to
reject the request to upgrade.
One of the following scenarios occurs:
•
If you choose to accept, the display shows Upg Rx
In Prog to indicate the upgrade received is in
progress.
If the upgrade is successful, the display shows
Program done.
If the upgrade fails, the display shows Program
failed. The radio remains in current
configuration.
• If you choose to delay, the radio prompts to
upgrade in the next power up of your radio.
•
If you choose to reject, the display shows Upg
Aborted. The radio continues to function with the
current configuration until it gets reprogrammed.
Note: If your radio has problems upgrading over-the-
air, consult a qualified technician for details.
Voice Announcement
This feature enables the radio to audibly indicate the
current feature mode, zone or channel the user has
just assigned. This audio indicator can be customized
per customer requirements. This is typically useful
when the user is in a difficult condition to read the
content shown on the display.
Each voice announcement is within a limit of three
seconds maximum. The sum duration of all different
voice announcements in a radio shall be no more
than 1000 seconds.
Note: This feature must be preprogrammed by a
qualified radio technician.
Check with your agent if Voice Announcement is
available for the feature you need.
The two options of priority for the Voice
Announcement available are:
High Enables the voice of the feature to announce
even when the radio is receiving calls.
Low Disables the voice of the feature from
announcing when the radio is receiving calls.
159
English
To Next Page
Loading...
Need help?
General
