If unsuccessful, you hear the radio sounds a
short, low-pitched tone.The display shows CLR
FAIL.
Note:
If Re-Pair Timer is set to infinite and you clear
keys on the radio, you must clear keys on all
previously paired devices as well. (Please see
your accessories manual for further details.)
Over-the-Air Programming (POP 25, ASTRO
25, ASTRO Conventional)
This feature enables configuration data and firmware
to be upgraded to your radio over-the-air. Full use of
the radio is retained during the data transfer without
interrupting communication. For ASTRO 25 and
ASTRO Conventional, the upgrade pauses to give
priorities to voice call, and continues after the voice
call ended. For Wi-Fi
®
, the upgrade process runs
concurrently with voice calls.
Once a configuration upgrade is downloaded to your
radio, you can install new changes immediately or
delay changes to be installed on the radio when it is
being powered up.
Note:
This feature must be preprogrammed by a
qualified radio technician. Check with your
dealer or system administrator for more
information.
Responding to the Notification of Upgrade
Voice Announcement
This feature enables the radio to audibly indicate the
current feature mode, zone or channel the user has
just assigned. This audio indicator can be customized
per customer requirements. This is typically useful
when the user is in a difficult condition to read the
content shown on the display.
Each voice announcement is within a limit of three
seconds maximum. The sum duration of all different
voice announcements in a radio shall be no more
than 1000 seconds.
Note:
This feature must be preprogrammed by a
qualified radio technician.
Check with your agent if Voice Announcement
is available for the feature you need.
76
English
To Next Page
Loading...
Need help?
General
