37
CHANNEL READY DELAY
CHANNEL READY DELAY
Press the or button until the Chan
Ready Dly? menu is shown. Press the ENTER
button to begin the next step.
Use the or buttons to cycle through the
Chan Ready Delay selections (8-120 seconds).
Press ENTER to select the new value, or
to exit without any changes. Default is
20-seconds.
Chan Ready Dly?
Old = 20 Sec
New = 20 Sec
The Motorola digital radio system will not broadcast while the radio channel is in use by others,
or if a mating digital receiver is not found (with an identical Channel No and Profile ID). The DLR
modem module will provide a “ready to transmit” signal if a mating digital radio is found, and if
the channel is not busy. To conserve battery power, the RF Module is powered down until needed
for a radio broadcast. After RF Module power-up, the system will verify the radio channel is clear
and a mating digital radio is available before message broadcast will occur. If a mating receiver
is not detected or a busy channel is detected, the system will attempt re-connection based Chan
Ready Delay value (configured using the LCD menu, “Chan Ready Delay? shown below).
In the example above, the Channel Ready Delay is set = 20 Seconds. If the Channel Ready signal
is not received, the system will re-try for a “Ready” channel every 4-seconds until a “Ready”
channel is detected, or until the 20-second Channel Ready Delay timer expires.
To Next Page
Loading...
Need help?
General
