39
SET DEFAULTS
SET DEFAULTS
This menu selection will reset the system to factory default values.
Press the or button until the Set
Defaults? menu is shown. Press the ENTER
button to begin the next step.
Set Defaults?
Press the ENTER button to set all values
to the factory default settings or any other
button to exit without any changes.
Are You Sure?
ENTER=Y ESC=N
NOTE: Setting factory defaults will modify
several system values that can prevent RF
broadcast connections to external radios.
Verify the external radio setting are correct on
the CB300-D after setting the default values.
SYSTEM DEFAULT SETTINGS
Channel: 1
ISD Volume: 1
LED Pattern: 2 (Logo Only)
RF Broadcast Volume: 30
Local Speaker Volume: 10
Total Call Cycles: 2
Call Cycle Delay: 45 (45-seconds)
Channel Ready Delay: 20 (20-seconds)
DLR Modem Profile ID: 0000
To Next Page
Loading...
Need help?
General
