24
DEVICE & LCD WAKEUP
DEVICE WAKEUP
The following buttons will “wake-up” the
device:
ESC Button
Wake Up Button
Call Button
To program new messages, it is
recommended to use the button to
wake-up the CB300-D system to prevent an
outgoing broadcast over the radio system.
The CB300-D system will support up to 6
messages of 10 seconds each. The system
expects the following message order:
Message 1: Local Message (Message played
back on local speaker)
Message 2: Radio Message (Broadcast when
the Call Button is pressed)
Message 3: “Low Battery” radio broadcast
message.
LCD WAKEUP
The following buttons will “wake-up” the
LCD:
ESC Button
When the or Call Button is pressed, the
LCD is still disabled until any LCD Control
Button is pressed.
To Next Page
Loading...
Need help?
General
