34 Advanced settings
5. Enter the number. Press m to conrm.
6. Press > to return to standby.
NOTE
If you switch Easy call on,
EASY CALL
will be displayed on your screen in standby mode.
You can not set Easy call
ON
until an Easy call number has been stored.
8.4.3 Dial an Easy call number
When an Easy call number has been stored and the Easy call setting switched
ON
, press
any key (apart from >), to dial a number.
NOTE
When Easy call is switched
ON
, you can still answer any incoming call as normal.
8.5 Registration
Up to 5 handsets can be registered to one base station. Additional handsets must be
registered to the base before you can use them.
• The instructions described below apply specically to your D10 handset. If you wish to
register another manufacturer’s handset, the instructions may vary. In this case, please
refer to the manufacturer of the additional handset.
• The Master PIN is required before you can register or unregister handsets. The default
PIN is 0000.
8.6 Register a handset
At the base:
1. Press and hold the p button on the base station for at least 3 seconds. You have 90
seconds in which to register a handset.
At the handset:
1. Press m and scroll
d
to
ADVANCED SET
and press m.
2. Scroll
d
to
REGISTRATION
and press m.
3. Scroll
u
or
d
to display
REGIST. BASE
and press m.
BASE 1 2 3 4
is displayed and
the registered base number is flashing. Enter the number of the base on which you
wish to register your handset.
If you have only 1 base station, press 1. If you have 2 base stations, press 1 or
2
, etc.
4. When the display shows
PIN ?
, enter the base PIN and press m.
When the handset registers with the base, it is assigned a handset number.
8.7 Select a base
You can register your D10 handset with up to 4 bases. Once registered, you can switch
between bases, for example, bases at home and at work.
1. Press m and scroll
d
to
ADVANCED SET
and press m.
To Next Page
Loading...
Need help?
General
