17
Scan
English
SCAN
SCAN
You can monitor several channels in order to
receive any call that is transmitted on any of
these channels. Sixteen different channels can
be programmed into a scan list. Each channel
can share the same scan list or have different
scan lists assigned to them.
Once the radio’s scan operation is activated and
the radio detects a call coming through a
channel in its scan list, it switches to that
channel for you to receive the call.
STARTING OR STOPPING A SCAN
OPERATION
The LED Indicator will blink (yellow) during a
scan operation. It will stop blinking when the
radio switches to a channel.
1. Press the
Scan
key
to start a scan operation.
2. Press the
Scan
key again to stop the scan oper-
ation.
TALKBACK
If the programmable Talkback option is set, you
can respond to any calls received during the
scan operation by pressing the PTT before the
programmed hang-time ends. Check with your
dealer for details.
DELETING A NUISANCE CHANNEL
If a channel continually generates unwanted
calls/noise, you can temporarily remove it from
the scan list by performing a
Nuisance Channel
Delete
operation.
1. While the radio is on the Nuisance Channel,
press and hold the
Scan
key until you hear a
tone.
2. Release the
Scan
key.
Note:
You cannot perform a
Nui-
sance Channel Delete
on a pri-
ority channel or if there is only
one remaining channel in the
scan list.
#WarisPopUser.book Page 17 27, May 1998, 2:06 PM
To Next Page
Loading...
Need help?
General
