Motorola MBP35 User Manual

Getting started 9
ENGLISH
1. Loosen the screw in a counterclockwise direction using a small
screwdriver. Remove the battery cover.
2. Insert the wire tab of the rechargeable battery pack into the contact
slot as shown above and fit the battery pack into the compartment.
3. Close the battery compartment and tighten the screw in a clockwise
direction.
4. Press
p once to switch ON the parent unit.
- It will take a few seconds to start up the unit.
5. Press and hold
p to switch OFF the parent unit.
NOTE
When the battery level is low, the power LED will turn orange and will flash.
NOTE
When the unit is powered up with either the power adapter or using the
rechargeable battery pack, the LED will light up in green. If both the power
adapter and rechargeable battery pack are used, the LED will light up in red.
2.4 Parent unit power supply
1. Connect the small plug of the power adapter to the parent unit and
the other end to the mains socket (230V/50Hz).
NOTE
Only use the enclosed power adapter (6V DC / 1000mA).
2. Press
p to switch ON the parent unit. The power LED will light up
in green.
3. Press and hold
p to switch OFF the parent unit.

Motorola MBP35 Specifications

General

LED type	IR
Night mode	Yes
Sensor type	CMOS
Fixed focal length	2.5 mm
Number of illumination LEDs	8
Maximum range	122 m
Smartphone support	No
Number of lullabies	5
Interface	-
Frequency band	2.4 - 2.4835 GHz
Product color	Grey, Silver
LED indicators	Power
Display diagonal	3.5 \
Display number of colors	16.78 million colors
AC input voltage	230 V
DC input voltage	6 V
Power source type	AC, Battery
AC input frequency	50 Hz
Battery technology	Nickel-Metal Hydride (NiMH)