3-18 3-19
Wired LAN
Using cables and network adapters to connect to the Internet. Before setting up the
connection of Dynamic IP/PPPoE or Broadband (PPPoE) or Static IP, contact your Internet
Service Provider (ISP) or network administrator for assistance of setting up Internet
connection.
▶ Dynamic IP/PPPoE Connection
1. Open up
Settings
, find and click [Network & Internet].
2. Select [Ethernet] within the
Network & Internet
selection menu.
3. Select [Change adapter options] to bring out
Network Connections
window.
4. Right click on [Ethernet] to select [Properties] from the drop-down menu.
5. Open up
Ethernet Properties
window, find and select [Internet Protocol Version
4 (TCP/IPv4)] in
Networking
tab. Then click [Properties] to continue.
6. Click [Obtain an IP address automatically] and [Obtain DNS server address
automatically] in
General
tab. Then click [OK].
▶ Static IP Connection
7. Follow the previous steps 1 to 4 to continue.
8. Click [Use the following IP address] and [Use the following DNS server
addresses] in
General
tab. Fill the IP address, Subnet mask, Default gateway,
Preferred DNS server, and Alternate DNS server. Then click [OK].
To Next Page
Loading...
Need help?
General