2-5
Hardware Setup
n Close the socket by
1. Close the Load Plate
2. While pressing down lightly on Load Plate, engage the Load Lever.
3. Secure Load Lever with Load Plate tab under retention tab of Load Lever.
Smear thermal grease on the top of the CPU. Lower the CPU fan onto the CPU and
socket, and secure it using the attachments or screws provided on the fan. Finally,
attach the fan power cable to the CPU FAN adapter.
Cooler Installation
This processor has to fit a special cooling fan. When the processor
runs, it will increase the internal ambient temperature. A chassis with
a maximum internal ambient temperature of 38
o
C at the processor fan
inlet is a requirement. Failure to provide this could result in damage to
the board. Please make sure the cooler has been recommended by
Intel. For more details, go to http://www.intel.com.
Warning! Please make sure that you use a CPU cooler bundled with a
retention module to keep PCB from crookedness. A crooked SBC may
probably result in unknown problem.
To Next Page
Loading...
Need help?
General
