MTD 700 Series User Manual

3. Store in cold, dry place.
4. Recharge battery whenever the specific gravity is
less than 1.225, before returning to service, or
every two months, whichever occurs first.
3. N ever inflate to over 30 p.s.i. to seat beads. Ex¬
cessive inflation pressure when seating beads may
cause tire/rim assembly to burst with force suffi¬
cient to cause serious injury.
COMMON CAUSES FOR BATTERY FAILURE ARE:
1. Overcharging
2. Undercharging
3. Lack of water
4. Loose holds downs and/or corroded connections
5. Excessive loads
6. Battery electrolyte substitutes
7. Freezing of electrolyte
THESE FAILURES DO NOT CON¬
STITUTE WARRANTY.
INSTALLATION OF TIRE TO RIM
AC WARNING \
The following procedure must be
followed when removing or install¬
ing a tire to the rim.
1. Be sure rim is clean and rust free.
2. Lubricate both the tire and rim generously.
OFF-SEASON STORAGE
If the machine is to be inoperative for a period longer
than 30 days, prepare for storage as follows.
1. Clean the engine and the entire unit thoroughly.
2. Lubricate all lubrication points. Wipe the entire
machine with an oiled rag to protect the surfaces.
3. Refer to the engine manual for correct engine
storage instructions. The engine must be com¬
pletely drained of fuel to prevent gum deposits from
forming on essential carburetor parts, fuel lines
and fuel tanks.
4. Refer to battery storage instructions on page 16.
5. Store unit in a clean, dry area.
When storing any type of power
equipment in an unventilated or
metal storage shed, care should be
taken to rustproof the equipment.
Using a light oil or silicone, coat the
equipment, especially any chains,
springs, bearings and cables.
17

MTD 700 Series Specifications

General

Turning Radius	18 inches
Engine Type	Single-cylinder
Drive Type	Rear-wheel drive
Tire Size (Front)	15x6.00-6
Tire Size (Rear)	20x10.00-8