ALTERNATE IR CHANNEL
The T 758 has the capability to operate via Alternate IR channel. This is
practically useful if you have two NAD products that can be operated by
similar remote control commands. With alternate IR Channel, two dierent
NAD products can be controlled independently in the same zone by
setting each one to a dierent IR channel.
IR CHANNEL ASSIGNMENT
The T 758 and the AVR 4 remote control must be set to the same channel.
To change the Main Zone IR Channel on the T 758
• Press and hold SOURCE and then toggle STANDBY button to select
desired IR Channel – the VFD will show “IR Channel 1” or “IR Channel 0”.
The default IR Channel is “IR Channel 0”.
To change the IR Channel on the AVR 4 remote control
• Include a channel number before the library code. For AVR 4, library
code “10” is the default library table for “AMP” device. To select this “AMP”
library table for “IR Channel 0”, retain the library code “10” (or “010”).
• If you want to load the “AMP” library table on “IR Channel 1”, prex the
library code with “1” to indicate association with “IR Channel 1”. Load
then the “AMP” library table using the code “110”. Repeat the same for
MP (130) and TUNER (140).
SAMPLE SETUP OF TWO NAD PRODUCTS ON THE SAME ZONE
NAD T 758 and NAD C 326BEE are both defaulted to IR Channel 0. If [OFF]
button is pressed on the AVR 4 remote control (or SR 8 remote control for
the C 326BEE), both products will go to standby mode. Press [ON] and both
products will power up from standby mode.
To prevent both products from simultaneously going in and out of standby
mode along with other common commands, set each one to a dierent
IR channel. In this setup, we will keep C 326BEE and SR 8 remote control
defaulted to “IR Channel 0”. As for T 758, we will assign it to “IR Channel 1”;
the same applies to AVR 4.
Set T 758 and AVR 4 to “IR Channel 1” via the following procedure.
T 758
• Press and hold SOURCE and then toggle STANDBY button to
select “IR Channel 1”.
AVR 4
• Press and hold [AMP] in the DEVICE SELECTOR section of the AVR 4.
• While holding down the device button [AMP], press “1”, “1” and “0”
using AVR 4’s numeric buttons.
• Press [ENTER] while still holding down the device button [AMP]. The
AMP device selector will ash once to indicate that the library input
is successful.
With both T 758 and AVR 4 set to “IR Channel 1”, the C 326BEE can now be
remotely controlled independent of the T 758.
NOTE
Performing a Factory Reset for T 758 or AVR 4 will result to a return to the
factory default “IR Channel 0” setting.
IDENTIFICATION OF CONTROLS
AVR 4 REMOTE CONTROL
15
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
To Next Page
Loading...
Need help?
General
