GEM-TOUCH K Style Keypad Operating Guide
11
TU RN ING O FF T HE AL AR M (DIS ARMI NG) W HE N RE TU RN I NG
Disarming the System
1. Enter your premises through the entry/exit door. The keypad will sound a steady tone to remind you to disarm the
system before your entry delay time expires.
2. Tap "PRESS TO DISARM" (shown at left), enter your User Code and tap Disarm. The red ARMED light
will go out, indicating that the system has been disarmed.
• If you enter an invalid User Code, the keypad will beep 4 times, signifying an error. Re-enter your User
Code immediately. Note: 10 seconds before the entry delay expires, the keypad will emit a pulsing warning tone.
Alarm Indication / Silencing an Alarm
If the red ARMED light is flashing upon entry, an alarm occurred while you were away. The display will scroll the number(s) of the
violated zone(s). Proceed with caution! If you suspect that an intruder may still be on the premises, leave immediately and call
authorities from a neighbor's telephone!
To silence an audible alarm:
1. Tap "PRESS TO DISARM" (shown above), enter your User Code and tap Disarm. After the system is disarmed, the Window will
continue to display the number(s) of the zone(s) violated.
2. To reset the display, note the zones violated, tap/hold-down Reset and enter your User Code followed by Enter.
Ambush (Optional) My Ambush Code is ___________________
If an intruder forces you to disarm your system, enter your Ambush Code and tap Enter. Using your Ambush Code will send a silent alarm
to the central station. Simply enter the 2-digit code (prefix) just prior to your normal User Code.
• Example: If your User Code is 1 2 3 4 and your Ambush Code is 9 9, simply tap 9 9 1 2 3 4 Enter.
The red ARMED light will go out and the green STATUS light will turn on, as if the system were normally disarmed. The system will ap-
pear to be disarmed normally, and there will be no indication that a special "silent" alarm has been sent to the central station.
Disarm
To Next Page
Loading...
Need help?
General
