© National Instruments | A-1
A
Where to Go from Here
This section lists where you can find example programs for the cDAQ chassis and C Series
modules and relevant documentation.
Example Programs
NI-DAQmx software includes example programs to help you get started programming with the
cDAQ chassis and C Series modules. Modify example code and save it in an application, or use
examples to develop a new application, or add example code to an existing application.
To locate NI software examples, go to
ni.com/info and enter the Info Code daqmxexp. For
additional examples, refer to
ni.com/examples.
To run examples without the device installed, use an NI-DAQmx simulated device. For more
information, in Measurement & Automation Explorer (MAX), select Help»Help Topics»
NI-DAQmx»MAX Help for NI-DAQmx and search for simulated devices.
Related Documentation
Each application software package and driver includes information about writing applications
for taking measurements and controlling measurement devices. The following references to
documents assume you have NI-DAQmx 9.8 or later.
cDAQ Chassis Documentation
The NI cDAQ-9171 Quick Start or NI cDAQ-9174/9178 Quick Start packaged with your cDAQ
chassis, describes how to install your NI-DAQmx for Windows software, how to install the
cDAQ chassis and C Series module, and how to confirm that your device is operating properly.
The NI cDAQ-9171 Specifications, NI cDAQ-9174 Specifications, or NI cDAQ-9178
Specifications lists all specifications for your cDAQ chassis. Go to
ni.com/manuals and
search for your cDAQ chassis.
The NI cDAQ-917x Safety, Environmental, and Regulatory Information packaged with your
cDAQ chassis, includes important hazardous locations information (if applicable), compliance
precautions, and connection information for your cDAQ chassis. Go to
ni.com/manuals and
search for your cDAQ chassis.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
