National Instruments NI ELVIS III User Manual

Note Your host computer and the NI ELVIS III needs to be
connected to the same subnet (local network).
NI ELVIS III
Local Network
Host Computer
Router
If the connection is successful, you can see the IP address of the Ethernet
connection on the OLED display of the NI ELVIS III. Press and hold the user
programmable button (Button 0) on the le-hand side of the NI ELVIS III workstation
until you turn on the display. The IP address of the Ethernet connection appears
aer the
icon.
Tip Go to Setting up the Host Computer to set up the soware
environment.
Tip Go to Configuring the Device if you need to upgrade the soware on
the device or set up an administrator password.
Connecting to the Device via Wireless Network (Wi-Fi models only)
Complete the following steps to connect the NI ELVIS III to your host computer via a
wireless network.
1. Connect the Wi-Fi antenna to the NI ELVIS III as shown in the following figure:
© National Instruments
11
NI ELVIS III Getting Started

National Instruments NI ELVIS III Specifications

General

Brand	National Instruments
Model	NI ELVIS III
Category	Network Hardware
Language	English