National Instruments NI ELVIS III User Manual

To avoid such damage in handling the workstation and prototyping board, take the
following precautions:
■
Ground yourself using a grounding strap or by holding a grounded object.
■
Touch the antistatic package to a metal part of the computer chassis before
removing the workstation or prototyping board from the package.
Remove the hardware from the package and inspect it for loose components or any
sign of damage. Contact NI if the hardware appears damaged in any way.
Store the workstation and the prototyping board in the antistatic envelopes when
not in use.
Tip Go to
Installing and Powering the Hardware next.
Installing and Powering the Hardware
Before you set up and use the NI ELVIS III device, ensure that you have the required
items listed in the
What You Need to Get Started section.
1. Ensure that the power switch at the back of the NI ELVIS III workstation is
switched o.
2.
Connect the power supply.
3. Connect the Wi-Fi antenna and/or relevant cables based on the following:
a. For initial configuration and launching of the So Front Panels without
network access or programming, start with Connecting to the Device via
USB.
b.
For Ethernet connection configuration, start with Connecting to the
Device via Ethernet.
c. For wireless connection (Wi-Fi models only) configuration, start with
Connecting to the Device via Wireless Network (Wi-Fi models only).
Note The USB cable is also required for the initial
configuration of the wireless network.
© National Instruments
5
NI ELVIS III Getting Started

National Instruments NI ELVIS III Specifications

General

Brand	National Instruments
Model	NI ELVIS III
Category	Network Hardware
Language	English