National Instruments NI ELVIS III User Manual

■
Connecting to the Device via Wireless Network (Wi-Fi models only)
Connecting to the Device via USB
Complete the following steps to use a USB cable to connect the NI ELVIS III from the
USB device port to your host computer.
1. Connect the Type-C to Type-A USB 2.0 cable to the NI ELVIS III as shown in the
following figure:
2. Connect the other end of the USB cable to the host computer.
Notice Ensure that the host computer is powered on before
connecting the USB cable.
If the connection is successful, you can see the IP address of the USB connection on
the OLED display of the NI ELVIS III aer you
install the Measurements Live Support
Files. Press and hold the user programmable button (Button 0) on the le-hand side
of the NI ELVIS III workstation until you turn on the display. The IP address of the
USB connection appears aer the icon.
© National Instruments
9
NI ELVIS III Getting Started

National Instruments NI ELVIS III Specifications

General

Brand	National Instruments
Model	NI ELVIS III
Category	Network Hardware
Language	English