Network max level
Select a maximum level. This is to ensure the backlight is never too bright if the network level is set too
high.
Select between 5 to 10.
¼ Note: Backlight Offset settings relate to the individual handset, not to the system.
¼ Note: If the backlight level is changed on the handset the radio will send the backlight level to the
network excluding the offset.
Contrast
¼ Note: This function is also available as a Shortcut.
Select to make adjustment of the screens contrast, using the
and keys. Range is 00 to 10.
Radio setup
The Radio setup menu covers settings that are typically configured at installation.
Sensitivity
¼ Note: This function is also available as a Shortcut.
Select LOCAL or DISTANT to improve the sensitivity of the receiver either locally (LOCAL) or over distances
(DISTANT).
LOCAL is not recommended for use in open sea conditions. It is designed for use in areas of high radio
noise; for example, close to a busy port or city.
UIC
¼ Note: This function is also available as a Shortcut.
Select between USA, INT (International) or CAN (Canadian) channel banks. The selected channel bank is
displayed on the LCD. For more information about the Channel charts, refer to the relevant chapter in this
manual.
¼ Note: UIC is not available in EU country mode.
Power output
Select to toggle between High power (25 W – indicated by ) or Low power (1 W – indicated by )
transmission power for the entire channel bank. Low power transmission draws significantly less current
(about ¼) from the battery, so is recommended for short range communication and where battery
capacity is limited.
¼ Note: Some channels can’t be switched to high power and will show LO regardless of power output
setting in menu.
Channel name
¼ Note: This function is also available as a Shortcut.
Allows you the option to edit the channel name descriptions displayed on the screen. Select to edit the
description of the channel currently in use. It can be a maximum of 12 characters long.
Key beeps
¼ Note: This function is also available as a Shortcut.
Select to adjust key beep volume.
Volume can be set from 00 - 10 (where 00 is off, and 10 is loudest).
| 23
Radio menus | RS100 / RS100-B / V100 / V100-B User Manual
To Next Page
Loading...
Need help?
General
