English−17
English
For box contents, please refer to the printed contents sheet or setup manual provided in the box.
The accessories included depends on the location where the monitor was shipped.
1. Place monitor face down on a non-abrasive surface ().
2. Please rotate the monitor stand 90 degrees as shown in .
Please refer to “CAUTION 5”.
3. Attach the base stand to the monitor stand, then tighten the screw at the
base stand’s bottom ().
Reverse this procedure if you need to re-pack the monitor.
Please refer to “WARNING 8”.
Make sure to read “Important Information” on page 3 before installation.
1. Turn off the power to your computer.
2. Place your hands on each side of the monitor to tilt the panel to a maximum tilt angle and lift up to the highest position
().
Maximum Tilt
Screw
90°
To Next Page
Loading...
Need help?
General