UNIVERGE SV8300 Features and Specifications Manual (ISDN/Q-SIG)
NWA-033632-001, Issue 1
Page 19
Incomplete Number Handling
Incomplete Number Handling
General Description
When a DID number incoming from ISDN is incomplete, SV8300 can transfer the call to a predetermined sta-
tion or attendant console.
Operating Procedure
No manual operation is required.
Service Conditions
1. This feature is applicable for BRI and PRI. There is no condition with firmware version.
2. This feature should be set in a route basis in system data programming.
3. Maximum number of digits received from ISDN must be set by system data.
4. This feature is available for overlap receiving and en-block receiving. Incomplete Number Handling oper-
ation starts at following timing.
A: If Overlap Receiving is not provided
When SETUP message is received regardless of whether Send Complete Information Element is
provided or not
B: If Overlap Receiving is provided
a. When SETUP message is received including Send Complete Information Element
b. When INFO message is received including Send Complete Information Element
c. When the inter-digit timer is out during Overlap Receiving
To Next Page
Loading...
Need help?
General