10 of 22
CloudMesh Satellite – User Guide
UG01350 v1.00 14 July 2021
6 When the pairing process is complete, the CloudMesh Satellite’s LED light will indicate signal strength.
See the
LED indicators section below.
7 Position the CloudMesh Satellite in the desired location in your premises and begin using your new
mesh Wi-Fi network. You should refer to the LED signal strength table on the next page to determine
the optimal location to achieve the best signal strength.
Pairing via Ethernet cable
An alternative pairing method to using WPS (see page 9) is to use the Ethernet cable (supplied with the
satellite) connected to the Ethernet port of each device to pair the CloudMesh Satellite with a CloudMesh
Gateway.
1 Place the CloudMesh Satellite next to your CloudMesh Gateway.
2 Connect power to both devices, switch them on and wait for them to power on. If the CloudMesh
Satellite LED light is still flashing blue after ten minutes, continue to step 3 to pair it with the
CloudMesh Gateway manually.
3 Ensure that the CloudMesh Gateway is connected to the Internet.
4 Connect the Ethernet cable (supplied with the CloudMesh Satellite) into any of the LAN ports on the
back of each device.
5 Allow up to ten minutes for the CloudMesh Satellite to download information from CloudMesh
Gateway. The LED turns solid green, indicating that it has paired with the gateway.
6 Disconnect the Ethernet cable from both devices and wait 10 minutes. As the CloudMesh Satellite
attempts to pair with the CloudMesh Gateway, the LED will flash pink.
7 Position the CloudMesh Satellite in the desired location in your premises and begin using your new
mesh Wi-Fi network. You should refer to the LED signal strength table on the next page to determine
the optimal location to achieve the best signal strength.
LED indicators
Your CloudMesh Satellite LED follows this sequence when first turned on.
Sequence LED LED activity Meaning
1
Blinking green Powering up
2
Blinking blue Ready for pairing
T a b l e 5 – LED sequence on power up
To Next Page
Loading...
Need help?
General
