NetComm NTC-402 User Manual

NTC-402 – Telstra Private IP WAN Configuration Guide
4 of 11
CG01068 v. 1.0 October 2018
© NetComm Wireless 2018
Overview
The following diagram depicts a Wireless IP WAN connection with a NetComm Wireless NTC-402 router using
framed routing to allow an IP subnet that is part of the IP WAN to sit behind the NTC-402. The settings for this
hypothetical example are set out in the table below.
The server/work station/printer that are directly connected to the router will be part of the IP WAN network and is
reachable easily from IP WAN. All computers/servers on the LAN side must be the next hop from the NTC-402.
Limitation of framed routing is only one hop beyond the NTC-402 on the IP WAN.
Configuration Settings
Before you begin the configuration process make sure you have gathered all the requisite information from Telstra.
The following table contains example configuration settings to help you with your configuration.
I T E M
D E T A I L S
APN (Attribute 30)
telstra.corp
Authentication Method
CHAP (attribute 3 is enabled)
Username (Attribute 1)
user2@netcomm.com.au
Password (Attribute 3)
FrameR0ute
Framed-IP-Address (Attribute 8)
192.168.252.138 (automatically assigned as router’s WAN IP)
Framed-IP-Netmask (Attribute 9)
255.255.255.255 or /32
Framed-Route (Attribute 22)
10.30.4.0/24
Table 1 – Example Configuration Settings
Note – Each customer will have unique settings for his/her account.

NetComm NTC-402 Specifications

General

Brand	NetComm
Model	NTC-402
Category	Wireless Router
Language	English