NetComm NTC-402 User Manual

NTC-402 – Telstra Private IP WAN Configuration Guide
7 of 11
CG01068 v. 1.0 October 2018
© NetComm Wireless 2018
I T E M
D E S C R I P T I O N
T E L S T R A S E T T I N G S
IP Type
Use the default setting: IPv4
IPv4
SIM PIN Code
Enter the PIN code that you received with the SIM from
your service provider.
Enter your SIM card’s
unique PIN.
Dial Number
Accept the default setting.
N/A
Authentication
Set to CHAP (Challenge Handshake Authentication
Protocol)
CHAP
Username
It is required for your Telstra supplied SIM and is case
sensitive.
user2@netcomm.com.au
Password
It is required for your Telstra supplied SIM.
FrameR0ute
IP Mode
Set to: Dynamic
Dynamic
Prim/Sec DPN
Not required
empty
Roaming
Accept the default setting of not enabled.
 Enable
PDP header/data
compression
control
Accept the default setting: Off
Off
Save button
Click to save and apply the changes you have made.
Click to save.
Undo button
Click to close the section and discard any entries you have
made.
N/A
Table 2 – Virtual Server Rule Configuration page
Disable NAT and Network Monitoring
7 While remaining on the Internet Setup tabbed page scroll down to the 3G/4G Connection Common
Configuration section:
Figure 4 – 3G/4G Connection Common Configuration section

NetComm NTC-402 Specifications

General

Brand	NetComm
Model	NTC-402
Category	Wireless Router
Language	English