Step 4: Attach the antenna
Screw the antennas onto the sockets by turning them in a clockwise direction.
Please refer to the Device overview section for the antenna socket layout. If you
have an NTC-6200 Series router with GPS and have purchased a GPS antenna,
remove the socket cap from the GPS antenna socket and attach the antenna to
the socket in the same manner.
Step 5: Mount the router
Mount your router in a suitable location using the options listed in the Mounting
options section.
When selecting a location to mount the NTC-6200 Series router, keep in mind that
it features two high performance antennas designed to provide optimum signal
strength in a wide range of environments. If you nd the signal strength is weak,
try moving the router to a different place, mounting it differently or changing the
orientation of the antennas.
The signal strength LEDs update within a few seconds with a rolling average signal
strength reading. When selecting a location for the router, please allow up to 20
seconds for the signal strength LEDs to update before repositioning.
To Next Page
Loading...
Need help?
General
