NetComm NTC-6200-01 User Manual

| Wireless M2M
4
Device overview
NTC-6200-01, NTC-6200-02, NTC-6200-11 and NTC-6200-12 models
ITEM DESCRIPTION
1 SIM card slot Insert SIM card here.
2 Six-way terminal
block connector
Connect power source, ignition and I/O wires here. Power, ignition
and I/O wires may be terminated on the supplied terminal block and
connected to a power source. Refer to the diagram and table under
Step 5 of the Installing your device section for correct wiring of the
terminal block. Operates in the 8-40V DC range.
3 Reset button Press and hold for less than 5 seconds to reboot to normal mode.
Press and hold for 5 to 15 seconds to reboot to recovery mode.
Press and hold for 15 to 20 seconds to reset the router to factory
default settings.
4 RJ45 PoE
Ethernet port
Connect one or several devices via a network switch here. This
port can also optionally receive Power over Ethernet (802.3af PoE)
in which case the DC power supply can serve as a backup power
source if required. (PoE available on NTC-6200-01 and NTC-6200-
11 only).
5 Aux antenna
socket
SMA female connector for auxiliary antenna (receive diversity).
6 Mini USB 2.0
OTG port
Provides connectivity for optional external storage or a USB Ethernet
dongle. Supplies up to 0.5A to connected device.
7 GPS antenna
socket
SMA female connector for GPS antenna.
8 Serial port Female DB9 port supporting 9-wire RS-232, RS-485 or RS-422
(software selectable).
9 Main antenna
socket
SMA female connector for main antenna.

NetComm NTC-6200-01 Specifications

General

Brand	NetComm
Model	NTC-6200-01
Category	Network Router
Language	English