NetComm NTC-6200-01 User Manual

| Wireless M2M
14
Step 6: Connect the power and Ethernet cables
Connect power to your router using one of the following options.
Power over Ethernet (802.3af PoE) (NTC-6200-01 & NTC-6200-11 only)
Connect your router to a PoE injector or PoE network switch using the bundled
yellow Ethernet cable 8P8C. This method uses the Ethernet connection to power
and transfer data to and from the router.
DC power via the six-way / two-way connector
Remove the attached green terminal block from your router and connect to the
router’s power socket using a DC power supply, sold separately.
DC power via eld terminated power source
If an 8-40V DC power supply is available, you can insert the wires into the
supplied terminal block to power your router. Use a athead screwdriver to tighten
the terminal block screws and secure the power wires, making sure that you have
correctly wired the terminal block as illustrated below.
TERMINAL DESCRIPTION
+
Positive wire for power
-
Ground Wire
i Dedicated terminal for ignition detection
1
I/O Three terminals used for input/output
detection (please refer to the User Guide)
1
1 - NTC-6200-01, NTC-6200-02, NTC-6200-11 and NTC-6200-12 models only
The green power LED on the router lights up when a power source is connected.
Tip: You can connect both the PoE and DC power sources at the same time. When both are
connected, the DC power acts as backup to the PoE input (PoE option available on the
NTC-6200-01 and NTC-6200-11 only).

NetComm NTC-6200-01 Specifications

General

Brand	NetComm
Model	NTC-6200-01
Category	Network Router
Language	English