Reference Manual for the 54 Mbps Wireless Router WGR614 v5
Wireless Configuration 4-7
June 2004 202-10036-01
Default Factory Settings
When you first receive your WGR614 v5, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGR614 v5 router, use the procedures below to customize any of the settings to better meet
your networking needs.
How to Set Up and Test Basic Wireless Connectivity
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
1. Log in to the WGR614 v5 firewall at its default LAN address of http://www.routerlogin.net
with its default user name of admin and default password of password, or using whatever
LAN address and password you have set up.
FEATURE DEFAULT FACTORY SETTINGS
Wireless Access Point Enabled
Wireless Access List (MAC Filtering) All wireless stations allowed
SSID broadcast Enabled
SSID NETGEAR
11b/g RF Channel 11
Mode g and b
Authentication Type Open System
WEP Disabled
Note: If you use a wireless computer to configure WPA settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless router from a wired computer to make any further
changes.
To Next Page
Loading...
Need help?
General
