© 2005 Alamo Group Inc.
Section 4 - 8
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
Oil Cooler / Fan Assembly
Connecting Oil Cooler And Fan As-
sembly to Exterior Wire Harness
1. Oil Cooler / Fan Assembly. The Oil
cooler / fan assembly is for cooling the oil
being returned from the Motor Case Drain.
The fan is connected to the control box and is
turned on & off automatically. It set to run on a
program that will run the fan in the cooling
rotation for a designated time, then stop, re-
verse the rotation (cycle to clean debris off of
cooler, then stop and reverse the fan again
and begin the cycle all over again.
The connection to the cooler on the
exterior wire harness is marked with code R1.
The connection from the fan will have two
wires, a Blue (+ connection) and a black (-
connection) (See Figure 8).
Exterior wire harness con-
nection marked R1 connects
here
FIGURE 8
Swivel Cyl. Base End C1 Port (G/W Tie)
Swivel Cyl. Rod
End C4 Port (G Tie)
Door Cyl. Rod End
C3 Port (Y Tie)
Door Cyl.
Base End
C2 Port
(Y/W Tie)
Valve "A" Port to
P2 Diverter Port
Port (G Tie)
From Valve "A"
Port to P1 Diverter
Port (G / WTie)
FIGURE 6
FIGURE 7
Diverter Valve
FIGURE 9
To Next Page
Loading...
Need help?
General
