This manual is for use only by technical personnel qualified to carry out the installation.
No information given in this manual can be considered of any interest to the end user!
This handbook is enclosed with items A6, A6F and A700F and must not be used for different products!
IMPORTANT NOTICE:
The unit described in this handbook is designed to control one or two electromechanical actuators for the automation of doors or
gates. Any other use is considered improper and consequently forbidden by current laws.
It is our duty to remind you that you are carrying out operations on machine systems classified in the “Gates and automatic doors”
category and as such are considered particularly “hazardous”; it is your job to make them as “Safe” as is reasonably possible!
Only qualified, expert personnel may carry out installation and any servicing required, making the best possible job of it
and in compliance with the following Italian laws, standards or European directives:
• UNI 8612 standard (Motorised gates and main doors: construction criteria and protection devices against accidents)
• DPR No. 46 of 5/03/1990 (Standards for the safety of electrical installations, authorised personnel)
• Decree Law No. 459/96 of 24/07/96 (EEC directive 89/392, Machine Directive)
• Decree Law No. 615/96 of 12/11/96 (EEC directive 89/336, Directive on Electromagnetic Compatibility)
• Decree Law No. 626/96 of 26/11/96 (EEC directive 93/68, Low Voltage Directive)
When designing and producing its products, Nice observes (as regards the equipment) all the above standards but it is of
paramount importance that the installer too (as regards the systems) continues the strict observance of the same standards.
Unqualified personnel or those who do not know the standards applicable to the “Automatic gates and doors” category:
Must under no circumstances carry out installations and systems
Whoever carries out systems without observing all the applicable standards:
Will be held responsible for any damages that the system may cause!
CONTENTS:
Quick guide Page 20
1 Introduction 22
1.1 Description 22
2 Installation instructions 23
2.1 Installation 23
2.2 Diagram of connections 24
2.3 Description of connections 25
2.4 Notes about connections 26
3 Test 27
3.1 Adjustments 29
3.2 Functioning modes 30
4 Programming 30
4.1 Programmable functions 30
4.2 Description of the functions 31
Optional : PIU’ expansions card 33
Technical features of the unit 34
English
19
To Next Page
Loading...
Need help?
General
