5
GB
2.3.2) Fixing the front bracket
The front bracket (47) is fitted with its clamp to the gate according to
the distances D and E (see tables);
before fixing permanently:
1. Check that the closing line of the gear motor is perfectly
horizontal (fig.4)
2. Open and close the gate by hand to check it moves smoothly.
3. Remove the gear motor and weld the front bracket (47)
Fixing the rear of the gear motor (fig.5)
Fix MOBY to the bracket (45) using the fork (46), screw (55), washer
(59) and nut (61); completely tighten the latter and then unscrew it by
about 1/10 of a turn to give a little play.
Fixing the front of the gear motor (fig.6)
Fit the front fork of MOBY (34) into the front bracket (47) and clamp
with the screw (56) and washer (60).
2.3.3) Opening the gate outwards
To ensure the gate moves correctly, it may sometimes be necessary
to use a longer bracket (PLA6, optional) as shown in the figure.
A
E
B
E
C
D= 750mm D= 700mm D= 900mm D= 850mm
MB4005
MB4005 MB4015 MB4024 MB4605 MB4615 MB4006 MB5015 MB5024 MB5615 MB5016A
100mm
110mm
120mm
130mm
140mm
150mm
160mm
170mm
180mm
190mm
200mm
E= 625mm
E= 615mm
E= 605mm
E= 600mm
E= 590mm
E= 580mm
E= 570mm
E= 560mm
E= 550mm
E= 540mm
E= 530mm
E= 595mm
E= 585mm
E= 575mm
E= 570mm
E= 560mm
E= 550mm
E= 540mm
E= 530mm
E= 520mm
E= 510mm
E= 500mm
E= 775mm
E= 765mm
E= 755mm
E= 750mm
E= 740mm
E= 730mm
E= 720mm
E= 710mm
E= 700mm
E= 690mm
E= 680mm
E= 745mm
E= 735mm
E= 725mm
E= 720mm
E= 710mm
E= 700mm
E= 690mm
E= 680mm
E= 670mm
E= 660mm
E= 650mm
MB4015 MB4024 MB4605 MB4615 MB4006 MB5015 MB5024 MB5615 MB5016
2.4) Adjusting the limit switch
The limit switch allows the stop position of the gate to be adjusted,
thereby eliminating the need for travel stops and preventing the gate
from hitting them. Simultaneously, a microswitch disconnects power
from the motor.
A) Release the gear motor (see chapter 5)
B Loosen the screw (54)
C) Open the gate to the required position
D) Move the limit switch to the required position by turning the
screw
ETighten the screw (54)
F) Models MB4006 and MB5016 also have a limit switch for the
closing position.
max. 50mm max. 50mm
To Next Page
Loading...
Need help?
General
