To Next Page

To Previous Page

Note 1:

If the transmitter is memorised in “Mode I” any key can be

pressed.

If the transmitter is memorised in “Mode II” the entire proce-

dure must be repeated for each memorised key to be deleted.

Alternatively this function can be performed using the O-Box

or O-View programming unit.

10 – ENABLING (or disabling)

THE RECEIVER FOR TRANSMITTER

MEMORISATION

This function enables the user to prevent memorisation of new

transmitters when the procedures “in the vicinity”(factory

setting is ON) or with “enable code” (factory setting is ON)

are used as described in this manual. To enable or disable this

function, proceed as follows:

01. Disconnect the receiver from the power supply and wait 5

seconds.

02. Reconnect the power and switch on by pressing the

receiver key until the relative led has completed the sig-

nals indicating the type of code stored in the memory

(see paragraph 5) and the procedure is activated, indicat-

ed by 2 short orange flashes. Then release the key.

03. (within 5 seconds) Press the receiver key repeatedly to

select one of the following functions (Warning! – on each

press of the key the Led changes colour to indicate the

currently selected function):

• Led OFF = No lock enabled

• Led RED = Memorisation “in the vicinity” locked

• Led GREEN = Memorisation with “enable code” locked

• Led ORANGE = Both memorisation modes locked (“in

the vicinity” and with “enable code”).

04. (within 5 seconds) Press any key of a transmitter already

memorised on the receiver to save the selected function.

Alternatively the lock (or unlock) function can be applied using

the O-Box or O-View programming unit.

www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com

Nice NiceOne OXI Series User Manual

Questions and Answers: