14
EN
11 – MEMORISATION OF A TRANSMITTER
USING THE RECEIVER
“CERTIFICATE NUMBER
”
[with O-Box] – This procedure can only be used if a trans-
mitter is used with “O-Code” encoding and when in posses-
sion of the receiver “Certificate Number”.
The “CERTIFICATE” is a personal number (factory set) identi-
fying the single receiver to distinguish it from all others.
Use of this “certificate” simplifies the procedure required to
memorise the transmitter in the receiver, as it no longer oblig-
es the installer to work within the receiver operating range. In
fact the new procedure enables transmitter memorisation
from any distance, even far from the installation site (for exam-
ple from the installer’s office – fig. 9).
WARNING – The settings described in this chapter
require use of the O-Box or O-View programming unit.
For operation of these devices, refer to the relative
instruction manuals, also available on the internet site:
www.niceforyou.com.
• The models with “SM” connector
are connected to the
O-Box unit by inserting the receiver in the relative con-
nector.
• The models with universal connector
are connected to
the O-Box unit by means of a special cable (fig. 7-a)
which must be connected to the connector on the receiv-
er (see fig. 7-b).
OTHER FUNCTIONS
7
9
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
To Next Page
Loading...
Need help?
General
