To Next Page

To Previous Page

Pause Time

Step-by-step

Function

Obstacle

detection

sensitivity

Open gate

indicator

output

Motor force

control

5 Seconds

15 Seconds

30 Seconds

45 Seconds

60 Seconds

80 Seconds

120 Seconds

180 Seconds

Open - stop - close - stop

Open - stop - close - open

Open - close - open - close

Apartment block

Apartment block (more than 2” generates stop)

Step-by-step 2 (less than 2” generates partial open)

Dead man

Opening in semi-automatic mode, closing in

dead man mode

Very high sensitivity (lightweight gates)

Very high sensitivity

High sensitivity

Medium sensitivity

Medium-low sensitivity

Low sensitivity

Very low sensitivity

Very low sensitivity (heavyweight gates)

Gate Open Indicator function

Active if leaf closed

Active if leaf open

Active with radio output 2

Active with radio output 3

Active with radio output 4

Maintenance indicator

Electric lock

Set at 40%

Set at 50%

Set at 60%

Set at 80%

Set at 100%

Semiautomatic 1=40÷100% (1)

Semiautomatic 2=60÷100% (1)

Automatic = 0÷100% (2)

7.2.2) Level one programming (ON-OFF functions)

Level 1 functions are all factory set to “OFF”. However, they can be changed at any time as shown in Table 8. Follow the procedure careful-

ly, as there is a maximum time of 10 seconds between pressing one key and another. If a longer period of time lapses, the procedure will fin-

ish automatically and memorize the modifications made up to that stage.

1. Press and hold key [Set] (approx. 3 s)

2. Release the [Set] key when L1 LED starts flashing

3. Press keys [▲] or [▼] to move the flashing LED onto the LED representing the function to be changed

4. Press the [Set] key to change the state of the function (short flashing = OFF; long flashing = ON)

5. Wait 10 seconds before leaving the programme to allow the maximum time to lapse.

10s

Note: Points 3 and 4 can be repeated during the same programming phases in order to set other functions to ON or OFF

Table 8: changing ON-OFF functions Example

SET

7.2.3) Level two functions (adjustable parameters)

Table 9: programmable function list: level two

Input LED Parameter Led (level) Value Description

Adjusts the pause time, i.e. the time which

lapses before automatic closure. This will

only have an effect if automatic closing is

active.

Manages the sequence of controls associ-

ated with the Step-by-Step input or to the

1st radio command.

Controls obstacle detection sensitivity. Take

care that sensitivity is also influenced by the

force of the motor (see L5); the motor force

should always be adjusted beforehand, to

enable correct settings of obstacle detec-

tion sensitivity.

Adjust the function associated with the open

gate indicator output (regardless of the

associated function, when active, it supplies

a voltage of 24V -30 +50% with maximum

power of 4W).

After start-up of the motor, set the force to

adapt it to the weight of the gate. The con-

trol system also measures the ambient tem-

perature, increasing force automatically in

the event of particularly low temperatures.

Please refer to the front page for Run 2500I inverter

model instructions.

Brand	Nice
Model	RUN2500
Category	Gate Opener
Language	English

Nice RUN2500 User Manual

Table of Contents

Other manuals for Nice RUN2500

Questions and Answers:

Nice RUN2500 Specifications

Related product manuals