Nikon ECLIPSE E800 User Manual

6. Troubleshooting Tables
Electrical system
The lamp does not fight when
the power is turned on
Cause
Countermeasure
The power supply is not plugged in.
Plug the power cord into an outlet. (p. 32)
The cables between the microscope and the
power supply are not connected.
Connect the cables. (p. 32)
The sub-power switch is set to “EPI.”
Set the switch to “DIA.” (p. 8)
The lamp has not been installed.
Install the lamp. (p. 29)
The lamp is burned out.
Replace the lamp. (p. 29)
The specified lamp is not being used.
Use the specified lamp. (Refer to the electrical
standards on P.39.) (p. 28)
The specified lamp is not being used.
Use the specified lamp. (Refer to the electrical
standards on P.39.) (p. 28)
The lamp voltage control cable has not been
connected.
Connect the cable. (p. 33)
The lamp is near the end of its life.
Replace the lamp. (p. 29)
Inadequate brightness
no effect.
The lamp flickers; the brightness The connectors are not connected securely,
is unstable —-
The lamp is not plugged into its socket
securely.
Secure the connections.
Insert the lamp securely into its socket.
37

Nikon ECLIPSE E800 Specifications

General

Brand	Nikon
Model	ECLIPSE E800
Category	Microscope
Language	English