o
Check
points
o Focus, shutter speed and aperture can be confirmed
in
the viewfinder. If any
other warning indications appear, see page
101
.
o When you reach the end of the film roll, the film starts
to
rewind automatically.
o For mid-roll rewind, see page 36.
o For self-timer operation, see page
68.
o When the camera back
is
opened before the film
is
completely rewound
(before
E blinks), warning indication (blinking 0
__
and frame counter) appears
in
the LCD panel and viewfinder. Refer
to
page 103 for troubleshooting.
7.3
7.4
Film starts to rewind automatically when film reaches
the end of the
roll.
• 0
__
,
0_
and then 0 appear
in
the LCD panel a
nd
viewfinder during fi
lm
rewind and the frame counter counts down until rewind is complete.
• Pictures taken on frames beyond the indicated number of the exposures
for the film roll may be discarded
in
the process of developing.
~
I:
Film rewind can be changed not to start automatically when the
end of a film roll
is
reached (page
71)
.
~
13
: High-speed film rewind
is
normally executed. This film rewind can
be changed to quiet film rewind (page
74).
Confirm that film
is
completely rewound, then
remove film cartridge .
• Film
is
completely rewound when the frame counter shows blinking HE"
in
the
LCD
panel and viewfinder.
(E
appears without blinking when the
exposure meter
is
off.) Make sure the film
is
completely rewound
(E
is
blinking
in
the LCD panel and viewfinder), open the camera back away
from sunlight and remove the film cartridge by tilting it to one side.
29
z
Q
i
w
0.
o
o
~
To Next Page
Loading...
Need help?
General
