3 Slide the SIM card holder to unlock it (1), and use your fingernail to lift it. Make
sure the contact area would face down when the SIM card holder is lowered (2),
insert the SIM card into the holder, and lower the holder (3). Slide the card holder
to lock it (4).
4 Line up the contacts of the battery and the battery compartment, and insert the
battery. To replace the back cover, direct the top locking catches toward their
slots, and press down until the cover locks into place.
Charge the battery
Your battery has been partially charged at the factory, but you may need to recharge
it before you can switch on your phone for the first time. If the phone indicates a low
charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the phone.
3 When the phone indicates a full charge, disconnect the charger from the phone,
then from the wall outlet.
You do not need to charge the battery for a specific length of time, and you can use
the phone while it is charging.
Get started 7
To Next Page
Loading...
Need help?
General
