3URJUDP &KDQJH
Point Programming
10 AFP-300/AFP-400 Programming PN 50259:C1 06/19/97
3URJUDPPLQJ D 0RQLWRU
0RGXOH 00;
When you select a device, the control panel returns a screen that displays information
about the point. For example, Figure 15 shows information for a sample monitor
module (M101) on the panel display:
1RWH 6/& /RRS RQO\
DSSOLHV WR DQ $)3
)LJXUH 00; 3RLQW 6FUHHQ
The Type Code selection blinks, indicating that you can press the Next or Previous
Selection keys to scroll through the Type Code selections. Refer to Table 11, which lists
the function for all Monitor Module Type Codes. You can also do the following:
1. Use the arrow and alphanumeric keys to modify point information, such as the
CBE equation.
2. When finished modifying a point, press <Enter>; then use the Next or Previous
keys to select another point.
00; 'HIDXOW =RQH
$VVLJQPHQWV
Table 10 lists the monitor module address range and the default zone assignment for
each range:
Table 10 Monitor Module (MMX) Default Zones
Change default zones for a monitor module as shown in Table 11, “Autoprogramming
Default Fields.”
352*50 021,,25 02'8/( $''5
= = = = = 0
7ZRGLJLW DGGUHVV
6/& QXPEHU
' GHWHFWRU RU 0 PRGXOH
%OLQNLQJ 7\SH &RGH VHOHFWLRQ
Monitor Module Address Zone Default
01 through 19 Z04
20 through 39 Z05
40 through 59 Z06
60 through 79 Z07
80 through 99 Z08
1RWH 7KH 7\SH &RGH LV XVHG WR
FKDQJH WKH IXQFWLRQ RI D SRLQW
To Next Page
Loading...
Need help?
General
