To Next Page

To Previous Page

INA 15092:I 05/30/01

SECTION 2 THE MAIN PROGRAMMING MENU

The Programming Mode is accessed by entering the following (a Level Two password is required):

D } X

After entering the Programming Mode, the display will show the following Main Programming menu:

PRESS 1=PSYS,3=PPRG,4=FPRG,5=REMV,6=PSWD,7=MSG :

The Main Programming menu has six options shown below. NOTE: Option 2 of the Main Programming menu is reserved

for future use.

1=PSYS Partial System Programming - Selective programming of INA functions

3=PPRG Partial Point Programming - Selectively altering the operating parameters of annunciator

points.

4=FPRG Full Point Programming - Complete programming of annunciator points and their

respective operating parameters.

5= REMV Remove - Permits the selective removal (from INA memory) of any of the annunciator

points.

6=PSWD Password - Allows the programmer to assign custom five-digit Level One and Level Two

passwords.

7=MSG Message - Allows the Level Two programmer to define the custom 40-Character User Label

displayed on the CRT Monitor and the INA's Liquid Crystal Display (LCD).

Refer to Figure 2.0-1 for a flow chart of the Main Programming menu. Detailed information on the Main Programming

Options follows.

Notifier INA User Manual

Questions and Answers: