To Next Page

To Previous Page

Clear default display

The default display set above can be cleared by the following SysEx:

Host => Launchkey MK3:

Hex: F0h 00h 20h 29h 02h 0Fh 06h F7h

Dec: 240 0 32 41 2 15 6 247

It is recommended to use this message instead of clearing the display by the Set default display

message as this message also indicates it to the Launchkey MK3 that the DAW relinquishes the control

of the default display.

Set parameter name

The DAW Pot and Fader modes can receive specific names to display for each control using the

following SysEx:

Host => Launchkey MK3:

Hex: F0h 00h 20h 29h 02h 0Fh 07h <controlindex> [<character> […]] F7h

Dec: 240 0 32 41 2 15 7 <controlindex> [<character> […]] 247

The

parameter is as follows:

- 38h (56) – 3Fh (63): Pots

- 50h (80) – 58h (88): Faders

These names are used when the control is interacted with, showing a temporary display, where they

occupy the top row. Sending this SysEx while the temporary display is active has immediate effect (the

name can be updated “on the fly”) without extending the duration of the temporary display.

Set parameter value

The DAW Pot and Fader modes can receive specific parameter values to display for each control using

the following SysEx:

Host => Launchkey MK3:

Hex: F0h 00h 20h 29h 02h 0Fh 08h <controlindex> [<character> […]] F7h

Dec: 240 0 32 41 2 15 8 <controlindex> [<character> […]] 247

The

parameter is as follows:

- 38h (56) – 3Fh (63): Pots

- 50h (80) – 58h (88): Faders

These parameter value strings (they can be arbitrary) are used when the control is interacted with,

showing a temporary display, where they occupy the bottom row. Sending this SysEx while the

temporary display is active has immediate effect (the value can be updated “on the fly”) without

extending the duration of the temporary display.

If this message is not used, a default parameter value display of 0 – 127 is provided by the Launchkey

MK3.

Novation Launchkey MK3 User Manual

Questions and Answers: