Oki C3000 Series Manual

Menu functions > 29
USB MENU
This menu controls the operation of the printer’s USB data interface.
N ETWORK MENU
This menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.
ITEM SETTINGS EXPLANATION
SOFT RESET ENABLE / DISABLE Enables or disables the SOFT RESET command.
SPEED 12 / 480 Mps Selects the interface speed.
OFFLINE RECEIVE ENABLE / DISABLE OFFLINE RECEIVE.
SERIAL NUMBER ENABLE / DISABLE Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB
device connected to your PC.
NOTE
When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
ITEM SETTINGS EXPLANATION
TCP/IP ENABLE /
DISABLE
Enables or disables this network protocol.
IP VERSION
IP V4 /
IPV 4 & V6
IPV 6
Sets up the IP version.
Operates with IPv4 only (not valid with IPv6).
Operates with both IPv4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
NETBEUI ENABLE /
DISABLE
Enables or disables this network protocol.
IP ADDRESS
SET
AUTO /
MANUAL
Specifies whether IP address allocation is automatic (DHCP) or manually
assigned.
IP ADDRESS xxx.xxx.xxx.x
xx
Current assigned IP address. To change, press ENTER and use +/– keys to
increment 1st octet, then press ENTER again to move on to next octet.
When 4th octet has been set, press ENTER again to register new address.
SUBNET
MASK
xxx.xxx.xxx.x
xx
Current assigned subnet mask. To change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.x
xx
Current assigned gateway address. To change, proceed as above.
WEB ENABLE /
DISABLE
Enables or disables Web config. facility.
TELNET ENABLE /
DISABLE
Enables or disables Telnet config. facility.
FTP ENABLE /
DISABLE
Enables or disables communication via FTP.
SNMP ENABLE /
DISABLE
Enables or disables SNMP protocol.

Oki C3000 Series Specifications

General

Brand	Oki
Model	C3000 Series
Category	Printer
Language	English