Faxing
> 87
F
AXING
S
ENDING
A
FAX
FROM
THE
MFP
This section details how to send a fax directly from your MFP.
B
ASIC
OPERATION
1. Place your document(s) with text face UP in the ADF or face DOWN on the glass.
2. Press the Fax button (1) on the control panel to prompt the Fax Mode screen.
3. Ensure Fax is highlighted, then press OK.
4. Set your destination and send properties as required. Refer to “Advanced operation”
on page 88 for details.
5. Press the Mono button (2) to start sending your document(s).
NOTE
If your Administrator has enabled access control on your machine, it will
automatically start up in access control mode. You will not be able to use it
until you have provided valid login information. Refer to “User authentication
and access control” on page 38 for details.
When faxing, you can load only A4, letter, or legal size documents in the ADF,
and A4 or letter size documents on the document glass. You cannot load mixed
size documents.
NOTE
If you wish to cancel faxing, press Stop (3) to abort the operation.
You can cancel a job that is being transmitted as long as the message
indicating the job has been completed has not displayed. Refer to “Fax job
view/cancel” on page 97 for details on how to cancel a reserved job.
When you select a broadcast job, the job itself is cancelled. If you want to
cancel an individual destination within a broadcast job, refer to “Deleting
specified destinations” on page 90.
Fax transmissions are sent in black and white only.
To Next Page
Loading...
Need help?
General
