EasyManuals Logo
Home>Olympus>Digital Camera>FE-115/X-715

Olympus FE-115/X-715 User Manual

Olympus FE-115/X-715
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Troubleshooting
8
Appendix
91
The batteries ran out of
power during shooting or
while the images were
being written to the
internal memory or card.
(Monitor turns off.)
Replace the batteries with new ones, or
charge the batteries. (Wait until the orange
lamp turns off when blinking.)
There is a problem with
the card.
See “Error codes”. P. 89
The monitor is hard to see.
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand.
Vertical lines appear on
the monitor screen
during shooting.
Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear
on the screen. This is not a malfunction.
The date recorded with the image data is wrong.
The date/time is not set. Set the date/time. The clock adjustment is
not factory-preset.
P. 52
The camera has been
left with the batteries
removed.
If the camera is left for 1 day with the
batteries removed, the date/time setting is
canceled. Set the date/time again.
P. 52
The picture is out of focus.
The subject was too
close.
Move further away from the subject. To take
pictures closer than 20 cm (7.9") with the
zoom in the maximum WIDE position, use the
super macro mode.
P. 31
Auto focus is not
possible.
Use focus lock to focus on the subject and
then shoot.
P. 18
There is condensation*
on the lens.
Turn the camera off and wait until it dries
before turning it on again.
The monitor goes off.
The camera is in the
sleep mode.
Press the shutter button or l.P.55
The flash does not fire.
The flash is set to [$]. Select a flash mode other than [$]. P. 32
The subject is
illuminated.
If you want the flash to fire on a brightly
illuminated subject, set the flash to [
#
].
P. 32
Movie mode or super
macro shooting is set.
The flash does not fire in the movie mode or
super macro shooting.
P. 34
* Condensation: When it is cold outside, the water vapor in the air is rapidly cooled and
turns to droplets of water.
Condensation occurs when the camera is suddenly taken from a cold
place into a warm room.
Possible cause Corrective action
Ref.
page

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Olympus FE-115/X-715 and is the answer not in the manual?

Olympus FE-115/X-715 Specifications

General IconGeneral
BrandOlympus
ModelFE-115/X-715
CategoryDigital Camera
LanguageEnglish

Related product manuals