H8CA-S
12
H8CA-S
Omron Europe B.V. EMA-ISD, tel:+31 23 5681390, fax:+31 23 5681397, http://www.eu.omron.com/ema
Cat. No. GC CN4A 6/98/26M Specifications subject to change without notice. Printed in the U.S.A.
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches, divide by 25.4.
P3GA-11
Y92F-30
H8CA-S
+
Adapter
91.9
8
Wiring duct, etc.
Hook
20
Panel
105.7
P2CF-11
H8CA-S
■PANEL MOUNTING
Using Y92F-30 adapter for flush mounting
Insert the H8CA-S into a square-cut hole from the front of the
mounting panel; insert the adapter from the rear of the
H8CA-S until the clearance between the panel surface and the
adapter is minimized. Then secure the H8CA-S with two
screws onto the panel.
Mounting
There is no limitation in mounting direction. However, avoid
mounting the unit at an angle.
■SURFACE MOUNTING
Using P2CF-11 front connecting socket
When a number of the H8CA-S are mounted in a vertical line
or when an H8CA-S is mounted close to an obstacle such as a
wiring duct, be sure to provide a separation of approx. 20 mm
(0.79 in.) between adjacent units or between the unit and the
obstacle to allow room for engagement and disengagement of
hooks as shown below.
By attaching the P3GA-11 back connecting socket to a panel
mounted H8CA-S, wiring can be performed in the same
manner as the front connecting socket.
Removal
To remove an H8CA-S panel mounted with a Y92F-30
adapter, loosen the two screws of the adapter, pry up the top
and bottom hooks of the adapter, and pull the H8CA-S out
from the front of the panel.
Caution
The H8CA-S has a built-in lithium battery. Be sure to
dispose of the old H8CA-S properly, as lithium batteries
are likely to explode if incinerated.
When mounting two or more counters in a vertical line,
arrange all the adapters so that the molded springs of the
Y92F-30 adapters are positioned on the right and left sides.
Molded spring
Molded spring
When mounting two or more counters in a horizontal line,
arrange all the adapters so that the molded springs of the
Y92F-30 adapters are positioned on the top and bottom sides.
To Previous Page
Loading...
Need help?
General
