Omron HEM-780 User Manual

3. Inflation stops and the measurement is started. When the
measurement is completed, your blood pressure and pulse rate
appear on the display.
SELECTING THE USER ID
Select your USER ID. Always use the same USER ID when taking a
measurement. The monitor stores the measurement values in the
memory by the USER ID selected. These measurement values are
used to calculate the Morning Averages and Evening Averages.
Slide the USER ID Selection Switch up or down to select USER A or B.
USING THE USER ID
When you select a USER ID the monitor can be set to take one
measurement using the Single Mode or three consecutive
measurements using the TruRead
TM
Mode when you press the
START/STOP button.
NOTE: The default value is set to the Single Mode to take
one measurement.
The TruRead
TM
Mode takes three consecutive measurements. The
monitor will inflate, take a measurement, and deflate three times
separated by a short interval of time between each measurement.
TAKING A MEASUREMENT
27
HEM-7080-updated Sept 22.qxd 9/22/06 3:46 PM Page 27

Omron HEM-780 Specifications

General

Model	HEM-780
Category	Blood Pressure Monitor
Display	LCD
Measurement Method	Oscillometric
Measurement Range (Pressure)	0-299 mmHg
Accuracy	Pressure: ±3 mmHg, Pulse: ±5% of reading
Inflation	Automatic by electric pump
Power Source	4 x AA batteries or AC adapter
Features	Irregular Heartbeat Detection
Measurement Range (Pulse)	40-180 beats/minute
Deflation	Automatic
Weight	Approx. 340g (without batteries)