Omron Micro A-I-R NE-U22 User Manual

17
How to Disinfect the Unit How to Replace the Mesh Cap
2 Remove the Mesh Cap
from the Medication Bottle
3 Install a new Mesh Cap.
- The nebulization rate may vary
depending on the type of Mesh
Cap you use.
You can usually use a Mesh Cap for approximately 1 year (according to the test result of
OMRON). However, the unit may not nebulize even before using it a year depending on
how you use it. The unit also may not nebulize or nebulize extremely weak even after
disinfected by boiling. In those cases, replace the Mesh Cap with a new one.
(Mesh Cap is a consumable part.)
For the inquiry on where to purchase the Mesh Cap or the broken or lost accessory,
contact the store where you purchased the unit or the nearest OMRON dealer.
Medication Bottle
Disengaging Button
1 Remove the Medication
Bottle from the Main Unit.
- Lift up the Medication Bottle from
the Main Unit by pushing in the
Medication Bottle Disengaging
Buttons from both sides and
releasing the engagement.
Lift up the Mesh Cap by
applying your thumb on
the brim.
Lift up the
Mesh Cap
perpendicular
to the
Medication
Bottle.
Do not insert your
finger into the
Nebulization Port.
Do not insert your
finger into the
Nebulization Port.
Insert the Mesh Cap
perpendicular to the
Medication Bottle.
Align these points,
then push in as far
as it goes.
Close the Mesh Cap
securely.
How to Replace the Mash Cap
EN-p2-20-(NE-U22)-3 3/25/02 4:48 PM Page 17

Omron Micro A-I-R NE-U22 Specifications

Power

power source	3 VDC (two AA alkaline batteries), 2.4 VDC (two AA nickel-hydrogen batteries)
power consumption	1.5 W

Technical Specifications

ultrasonic frequency	180 kHz
nebulization rate	0.25 ml / minute or more
particle size	5 µm

Capacity and Dimensions

medication bottle capacity	7 ml
external dimensions	38 (W) x 104 (H) x 51 (D) mm
weight	97 g

Battery and Operating Life

battery life with continuous nebulization	4 hours
battery life with daily use	8 days
operating temperature	10 to 40°C