Omron NJ501 User Manual

7．Connection Procedure
10
7.2. Work Flow
Take the following steps to make the connection settings for remote I/O communications of
DeviceNet.
7.3 Setting Up the Controller Set up the Controller.
↓
7.3.1 Hardware Settings for the
DeviceNet Unit
Set the hardware switches on the DeviceNet Unit
and connect to the Controller.
↓
7.3.2 Starting the Sysmac Studio and
Setting Parameters for the
Controller
Start the Sysmac Studio and set the parameters for
the Controller.
↓
7.3.3 Setting the Global Variables Set global variables used for the remote I/O
communications.
↓
7.3.4 Going Online and Transferring
the Project Data
Go online with the Sysmac Studio and transfer the
project data to the Controller.
↓
7.3.5 Settings in Watch Tab Page Make settings in the Watch Tab Page to check data
that are sent and received.
↓
7.4 Setting Up the Safety Network
Controller
Set up the Safety Network Controller.
↓
7.4.1 Hardware Setting
Set the hardware switches on the Safety Network
Controller.
↓
7.4.2 Starting the Network Configurator
and Creating Network
Configuration
Start the Network Configurator and set the network
number.
↓
7.4.3 Setting the Devices Set the devices offline
↓
7.4.4 Transferring Device Information Transfer the device information to the DeviceNet
Unit and the Safety Network Controller.
↓
7.5 Connection Status Check Check the status of the DeviceNet network
connection.
↓
7.5.1 Checking the Connection Status Confirm that the DeviceNet communication is
correctly performed.
↓
7.5.2 Checking Data that are Sent and
Received
Confirm that the correct data are sent and received.

Omron NJ501 Specifications

General

Brand	Omron
Model	NJ501
Category	Controller
Language	English